Gotham Spoiler for Tesla Model S
More Information

Gotham Spoiler for Tesla Model S

EVANNEX presents our Gotham spoiler in high-gloss carbon fiber designed exclusively for the Tesla Model S. Following the lines and curvature of the trunk hatch, the Gotham spoiler has been designed with an avant-garde edgy look that will give your Model S attitude. The distinctive look of the Gotham spoiler presents two “mini-wings” on each end that showcase a futuristic look for a futuristic car. Lightweight and extremely strong, the eye-catching Gotham spoiler will turn heads and differentiate your Tesla Model S from others on the road.






Gotham is constructed with a fiber glass core that is covered with real 3K 2x2 twill carbon fiber with a high-gloss finish. The overall curve of the Gotham spoiler matches the rear edge curve of the Model S trunk hatch door. Centered on the rear Tesla “T” badging, the Gotham spoiler spans almost the entire trunk hatch width, complementing the longitudinal accent features on both sides of the trunk hatch.

The Gotham spoiler dimensions are shown in the Figure below: 


The Gotham spoiler is 46.6 in. (1190 mm) from tip-to-tip with an overall arch height of 10.5 in (265 mm). The nominal center width of the spoiler is 2.9 in. (74 mm) and the width at the “mini-wings” is 3.7 in. (94.5 mm). The vertical height above a horizontal plane (i.e. the height of the spoiler when lying flat) is 1.4 in. (36 mm).

The adhesive used to attach the spoiler to the trunk hatch surface is a high-strength automotive double-sided adhesive tape. The tape uses an acrylic foam which is viscoelastic in nature, giving the tape energy absorbing and stress relaxing characteristics. The tape provides strong tensile and shear strength. The tape is pre-applied to the underside of the spoiler in a pattern that is most appropriate for strong adhesion.






Slideshow Presentation


PDF File

Download PDF Instructions




Are tools or screws required to install the Gotham spoiler?

No tools or screws are required. The spoiler is attached to the trunk hatch surface using high strength automotive adhesive.

Is the Gotham spoiler difficult to install?

Although care must be taken when planning the installation, the steps required are relatively straightforward. 

Is the Gotham spoiler compatible with all years and configurations (Including the Refresh) of the Model S?

Yes, the Gotham spoiler is compatible with all Model S.

I’m just not a DIYer. What should I do? 

If you’re the least bit uncomfortable with the Gotham spoiler installation, you can bring the spoiler to a installation professional, who can install the spoiler in less than 30 minutes.

Will the spoiler impact the aerodynamics, range, or handling of my Tesla Model S?

Generally, a spoiler is an automotive aerodynamic device whose intended design function is to 'spoil' unfavorable air movement across a body of a vehicle in motion, usually described as turbulence or drag. Spoilers are often fitted to race and high-performance sports cars, and aftermarket spoilers are generally added to cars primarily for styling purposes and have little aerodynamic benefit. Note: we haven't conducted aerodynamic studies on the Gotham spoiler to assess the impact of the spoiler on these characteristics, but, it's likely that the spoiler will have only a minimal impact on range, aero, and handling - certainly less than 1 to 2 percent, if any. 

Will the adhesive used to attach that spoiler be strong enough to stand up to air pressure during high speed driving?

The automotive adhesive is very strong. Your spoiler will remain attached at high speed. 

If it possible to remove the spoiler once it has been attached and will there be any permanent damage to the car surface? 

It is possible to remove the spoiler. Simple acquire a fine fishing line, cut about a 20 inch length and slip the line under the tip of the spoiler between the carbon fiber and that car’s surface. Using a sawing action, break the adhesive bond as you move across the entire length of the spoiler. There will be adhesive resident that remains. Most of it can be removed with your finger, and what remains can be removed using acetone or another cleaner.

Can the EVANNEX Car Cover be used with the spoiler installed?

Yes. The EVANNEX car cover will fit with no problem.

Does EVANNEX sell other exterior carbon fiber accents that would further complement the Gotham spoiler?

Yes. We offer a variety of additional carbon fiber accents for the Model S exterior called Accent-E. Among the most popular are carbon fiber B-pillar accents, door handle appliques, and a carbon fiber accent for the top of the nose cone for pre-2016 Model S vehicles.  

Are there any special conditions associated with returning the spoiler?

The spoiler may be returned at your own cost using the packaging and box that it was shipped in. Once we receive and inspect it, you will receive a full refund. However, the spoiler may NOT be returned if you remove the red backing on the double-sided adhesive. Once the backing is removed, the spoiler cannot be resold or reused. So before you attach the spoiler permanently, place it on the trunk hatch to assess the look. Do not remove the red adhesive backing until you decide to keep the spoiler.

How long is your shipping timeframe?

For U.S. orders, we target shipment of the Gotham spoiler in 1 - 3 weeks.

Does the Gotham spoiler ship to international destinations?

Yes! We ship daily to locations worldwide via FedEx International. Please allow extra time for international shipments. For more on international shipping, visit our "Shipping and Fulfillment" page. 




"Here are some photos of the [Gotham] spoiler and caliper covers. Both look awesome, thanks!!!" - Steve C., Leesburg, VA


Source: Steve



Ask a Question

Have a Question?

Please ask your question below.


Please Confirm You've Read Our Terms

Before we add your item to your cart, we need to confirm you have read and agree with our:

Links will open in new window.

Yes, I Agree. Add to Cart!

No, Please Cancel